μŠup, STEMMA QT, Qwiic JST-SH 4-pin cable - dupont female
μŠup, STEMMA QT, Qwiic JST-SH 4-pin cable - dupont male
μŠup, STEMMA QT, Qwiic JST-SH 4-pin cable with test hook
1 gram of 3D printing of your uploaded folder from ASA material.
1 gram of 3D printing of your uploaded PET file.
1 gram of 3D printing of your uploaded PLA file.
GeB Li-Ion Battery 2x18650 2S1P 7.4V 3200mAh
Proximity and gesture sensor GY-9960LLC APDS-9960, RGB, I2C.
LaskaKit printed pad under the board Arduino UNO with place for non-soldering field.
LaskaKit 3d printed Arduino Uno Light Bumper that you put under your board so you don't accidentally scratch your desk or short it.
Our sensor combines temperature measurement between -40 and 80°C, pressure between 300-1100hPa and humidity up to 100% RH with the BME280 chip.
LaskaKit box for automatic tester LCR-T4
LaskaKit box for digital thermostat W1209
LaskaKit box for digital thermostat W1209 in the panel
LaskaKit box for digital thermostat W1401
LaskaKit box for digital thermostat W1401 in the panel
LaskaKit box for ESPD-35
LaskaKit box for ESPink-4.2. Attention, only for touchless versions
Case for the LaskaKit ESPink-4.26 ESP32-S3 e-Paper. It is made of PETG material by 3D printing. This makes it lightweight and durable.
LaskaKit box for laboratory load 150W
LaskaKit box for LaskaKit ESPlan
Box for LaskaKit ESPwled. It is made of PETG material by 3D printing. This makes it lightweight and durable.
LaskaKit box for LaskaKit IoT E-ink-1.54 kit
LaskaKit box for LaskaKit IoT OLED kit
You are on page 8 of 11.
