LaskaKit, Page 9

As you can see in the picture above, there's a lot on the board. The board is powered by a connected battery, which can be charged via an integrated charge controller from the...

The board is an ideal choice for smart home enthusiasts who want maximum control over low-voltage loads and lighting. The simple setup and flexibility of the ESP32-C3 makes this...

Our starter kit with a range of electrical components such as LEDs, buttons and resistors.

Set of potentiometric multi-turn trimmers in ten different resistors.

LaskaKit Printednest Rocket Lamp kit

The board is specially designed for easy creation of robotic constructions. It is based on the proven ESP32 microcontroller and contains two dual motor controllers allowing...

Set of 1000pcs classic resistors with wire terminals, 34 values 1R - 10M, 20 to 50 pieces per value, 0,25W 5%

Set of 2440 resistors with 122 different values of 20 pieces each.

LaskaKit set of parts for SMARS modular robot

A set of plastic gears is usually intended for use in mechanical projects such as models, prototypes, or small machinery.

LaskaKit resistor and capacitor set in smd 0805 package.

LaskaKit set of brass screws, nuts and spacers, perfect for fixing and organizing your projects.

LaskaKit shield for box for Senserion SEN 54 and SEN 55 optical air quality sensor

The LaskaKit μŠup-SP13-I2C cable is used to connect our development boards with the μŠup-I2C connector and the SP13 4pin waterproof connector. Thanks to its length of 5 cm and...

Printed parts for LaskaKit Meteo Micro Weather Station

Printed parts for LaskaKit Meteo Mini Weather Station

Control module specially designed for stepper motors. The module has a number of built-in fixed modes of operation that allow users to quickly select the appropriate trajectory...