Lithium-polymer battery with a capacity of 2000mAh with a nominal voltage of 3.7V.
Lithium polymer battery with 1500mAh capacity.
Lipo cell with 850mAh capacity and nominal voltage 3.7V.
Directly designed for our AirBoard and Optical Air Quality Sensor Sensirion SPS 30
Proximity and gesture sensor GY-9960LLC APDS-9960, RGB, I2C.
LaskaKit printed pad under the board Arduino UNO with place for non-soldering field.
LaskaKit 3d printed Arduino Uno Light Bumper that you put under your board so you don't accidentally scratch your desk or short it.
LaskaKit box for automatic tester LCR-T4
LaskaKit box for digital thermostat W1209
LaskaKit box for digital thermostat W1209 in the panel
LaskaKit box for digital thermostat W1401
LaskaKit box for digital thermostat W1401 in the panel
LaskaKit box for ESPD-35
LaskaKit box for ESPink-4.2. Attention, only for touchless versions
Case for the LaskaKit ESPink-4.26 ESP32-S3 e-Paper. It is made of PETG material by 3D printing. This makes it lightweight and durable.
LaskaKit box for laboratory load 150W
LaskaKit box for LaskaKit ESPlan
Box for LaskaKit ESPwled. It is made of PETG material by 3D printing. This makes it lightweight and durable.
LaskaKit box for LaskaKit IoT E-ink-1.54 kit
LaskaKit box for LaskaKit IoT OLED kit
Box for LaskaKit Live-10.2 E-paper kit with WiFi for "Live Image". It is made of PETG material by 3D printing. This makes it lightweight and durable.
Box for LaskaKit Live-11.6 E-paper kit with WiFi for "Live Image". It is made of PETG material by 3D printing. This makes it lightweight and durable.
Box for LaskaKit Live-12.48 E-paper kit with WiFi for "Live Image". It is made of PETG material by 3D printing. This makes it lightweight and durable.
Box for LaskaKit Live-5.83 E-paper kit with WiFi for "Live Image". It is made of PETG material by 3D printing. This makes it lightweight and durable.
You are on page 9 of 11.
