KR601M RFID access reader 13.56MHz Wiegand IP65

Product detailed description

The KR601M waterproof RFID reader is used for access control to premises using an RFID card or key fob. It reads 13.56 MHz cards according to the ISO/IEC 14443A standard and transmits the read card number via a 34 or 26-bit Wiegand interface, allowing you to connect it to a standard access control panel or controller. Audio and visual signalling can be controlled by a master controller. Thanks to the IP65 rating, it can also be mounted outdoors.

WARNING! The reader is very difficult to disassemble after assembly due to its construction! It is recommended to complete the reader after it is fully debugged. So it is not a defect, but a specific design of the reader.

Specifications:

• Frequency: 13.56 MHz
• Supported cards: IC cards and key fobs according to ISO/IEC 14443A
• Reading range: approx. 5–10 cm
• Output: Wiegand 34 bit (default) / 26 bit
• Power supply: 12 V DC (±5 %)
• Power consumption:
  • Idle: < 80 mA
  • When reading a card: < 200 mA
• Signalling: buzzer and LED, externally controllable
• Protection rating: IP65 (outdoor use)
• Operating conditions:
  • Temperature: −10 °C to +50 °C
  • Humidity: 20–80% RH
• Storage temperature: −20 °C to +60 °C
• Dimensions: 86 × 86 × 16 mm

Connection:

• Red: VCC (+12 V)
• Black: GND
• Green: D0
• White: D1
• Purple: buzzer (active low – connect to GND)
• Grey: green LED (active low – connect to GND)
• Yellow: Wiegand format selection – disconnected = 34 bit (default), connected to GND = 26 bit

Package contents:

• 1× KR601M RFID reader

Note:

• This product is not a standalone functional unit and may require professional installation.
• Product images are for illustrative purposes only and may sometimes differ from the actual appearance of the item. However, this does not change their basic properties.