Newly Stocked

16-Channel Relay Module 5VDC is a switching board suitable for controlling up to eight separate devices with higher voltage or current.

LED indicator of the capacity status of one Lipo Li-ion battery on the voltage base between four states.

Large OLED display with a diagonal of 2.7" and a high resolution of 256×128 pixels, communicating via a two-wire I²C interface. It offers a bright white image on a deep black...

Module for capacity indication of up to two Li-ion batteries with 4 LEDs.

4-channel optoisolator module PC817

This 6 Degrees of Freedom (6DoF) robotic arm kit contains everything you need to build a fully functional arm - including 6 powerful MG996R servo motors. The anodised aluminium...

Converter from logic 3.3V to 5V or vice versa with eight channels, which is useful for connecting boards like ESP32 to peripherals operating on 5V logic.

The 8-channel relay module 5VDC is a switching board suitable for controlling up to eight separate devices with higher voltage or current. Each relay channel can switch up to...

Wifi module ESP-01 from AI-Thinker with its own integrated controller and several dedicated pins

A module from Ai-Thinker ESP-01S with an ESP8266 chip that allows it to communicate wirelessly using WiFi.

Atmel adapter between 10pin and 6pin connector.

Plastic holder for two AA batteries with switch.

Plastic holder for three AA batteries with switch.

Holder for four AA batteries with wire outlets, lockable case and switch.

Set of sixty-five wires for Arduino boards and modules with male-male connectors of various lengths.

Cable for stepper motor Nema 17 with connector JST-XH 1m

Keypads from the sensor suite detect the change in capacitance forming the touch buttons.

If you often tinker with Arduino, Raspberry Pi or other electronics, you know that proper connecting wires are essential! This set will offer you 300 pieces of wires different...

DIY MORE PH-4502C pH measurement module

Probe for measuring the acidity of a solution or pH. A converter is required for connection to the Arduino.

FitSain 775 DC Motor DC24V 20000 rpm + ER11 Precision Clamp

Foil 116x174mm for storage of SMD electronic components

GA12-N10 5V motor with gearbox

The module allows your board to communicate wirelessly using GPRS and GSM mobile networks. The module requires a prepaid microSIM card.