Wiring & PCB Boards, Page 10

Connection cable with JST-SH-4 connectors, pitch 1mm.

Connection cable with JST-SH-4 connectors, pitch 1mm.

Durable 150cm USB-A to USB-C cable for charging and data transfer. Suitable for phones, tablets and power banks. Offers current up to 2 A and voltage drop of only 0.45 V at 2 A...

USB cable with USB-B adapter used by Arduino UNO and MEGA boards.

A compact adapter with a 90-degree angled USB-C connector allows the cable to run along the device, significantly reducing strain on the connector.

A ready-made printed circuit board that allows you to easily make your own shield for Arduino Mega boards.

Set of sixty-five wires for Arduino boards and modules with male-male connectors of various lengths.

Conductors with stripped reinforced ends of various sizes for use with breadboards for cleaner wiring.

Cable for stepper motor Nema 17 with connector JST-XH 1m

Cable organizer 10mm - Velcro, length 3m

Car cigarette lighter connector with approx. 30cm long wires

Connecting cable for sensor modules to watch LilyGO T-Watch, length 30cm

Female-to-female wire dupont with a length of 70 cm and four pins.

Universal development board-programmer for ESP8266 modules with CH340 converter. Enables easy firmware uploading (Arduino IDE, PlatformIO, NodeMCU, MicroPython) as well as power...

Dupont jumper wire 40-pin M-F (male-female) is used for quick and reliable connection of Arduino, breadboards, modules or sensors without soldering. Each wire is equipped with a...

Super soft silicone Dupont jumper wires are ideal for quick and tidy connection of components on breadboards, development boards, or during prototyping.

FFC FPC unshielded flexible cable AWM 20624 80C 60V 0.5mm 24pin, 10cm for e-Paper adapter.

The DESPI-C02 module is a connection board that was designed to make it easier for users to work with the Good Display E-Paper Display.

The adapter enables the connection of seven color 7.3" e-Paper displays from the Good Display company with an SPI bus and a 50-pin connector.

ChargerLAB POWER-Z SINK240 is a trigger module that allows you to get the exact voltage you need from any USB-C charger.

The JST-PH-2 connector with a two-pin interface and wires is ideal for power or signal connections in small electronic projects. Its compact design and 2 mm pitch make it...

Adapter for connecting batteries with a JST-PH-2 (2mm) connector to devices with a locking JST-GH-2 (1.25mm) connector. Allows easy conversion without soldering or changing...

Colored insulated wire, 30AWG

SOT23 and SOP10 to DIP adapter