Connecting Cables, Page 6

Connection cable with JST-SH-4 connectors, pitch 1mm. The connectors are fitted on both sides.

Connection cable with JST-SH-4 connectors, pitch 1mm.

Connection cable with JST-SH-4 connectors, pitch 1mm.

Connection cable with JST-SH-4 connectors, pitch 1mm.

A 1 m power cable with 4 mm banana plugs on one end and a 5.5/2.1 mm DC jack male connector on the other connects devices with a DC power socket directly to a laboratory power...

This 1 m cable with 4 mm banana plugs on one end and a USB-A socket on the other allows you to power USB devices from a laboratory power supply.

A set of coloured interconnect cables with a 4 mm banana plug at one end and a 2.54 mm Dupont connector at the other connects a laboratory power supply or multimeter to a...

This set of five 1 m colour-coded test leads with fully insulated alligator clips on both ends is designed for the quick connection of power sources, batteries, loads, or...

This set of five colour-coded 1 m test leads, featuring a 4 mm banana plug at one end and an insulated crocodile clip at the other, is used for interconnecting power supplies,...

A pair of 1 m measuring cables (red and black) with a 4 mm banana plug on one end and an insulated crocodile clip on the other is used to connect a laboratory power supply or...

The ETA4508 set of five colour-coded test leads, featuring a 4 mm banana plug at one end and a fine IC hook at the other, is designed for measurements directly on chip and...

This set of four 1 m measuring patch leads with 4 mm banana plugs on both ends is used to connect laboratory power supplies, multimeters, electronic loads, or measured circuits.

This set of five colour-coded 1m test leads with 4mm banana plugs on both ends is used to interconnect power supplies, instruments, and socket panels.

The measuring patch lead with a 4 mm banana plug on one end and a crocodile clip on the other is an indispensable tool for every workshop and laboratory.

Set of sixty-five wires for Arduino boards and modules with male-male connectors of various lengths.

Conductors with stripped reinforced ends of various sizes for use with breadboards for cleaner wiring.

Cable for stepper motor Nema 17 with connector JST-XH 1m

Car cigarette lighter connector with approx. 30cm long wires

The Cleqee P1600A multimeter test lead set includes 4 mm banana plug cables and interchangeable tips – probes, piercing needles, and crocodile clips.

The RG316 coaxial patch cable, 30 cm in length with SMA male connectors on both ends, is used for connecting RF devices, modules, antennas and measuring equipment.

If you often tinker with Arduino, Raspberry Pi or other electronics, you know that proper connecting wires are essential! This set will offer you 300 pieces of wires different...

Female-to-female wire dupont with a length of 70 cm and four pins.

A pair of 1 m measuring cables (red and black) with fully insulated alligator clips on both ends is used for the quick connection of power sources, batteries, loads, or...

A set of colourful 30 cm cables with a test hook on one end and a Dupont connector on the other is used to connect a logic analyser, oscilloscope or development board to...