Converters & Programmers, Page 3

USB ISP programmer for ATMEL AVR with ATmega8L chip. 100% compatible with USBasp.

CH340G component in SOP16 suitable for conversion between several buses, most often USB and UART for programming.

XGecu PRO T48 universal memory and MCU programmer, USB

1-channel optoisolator module PC817

Converter from logic 3.3V to 5V or vice versa with four channels, which is useful for connecting boards like ESP32 to peripherals operating on 5V logic.

4ch I2C ADC converter for Raspberry Pi, ADS1115

4-channel optoisolator module PC817 24V to 3.3V

4-channel PC817 3.3V to 24V optoisolator module

4-channel PC817 24V to 5V optoisolator module

The DS18B20 temperature probe adapter is a practical module designed for easy connection of DS18B20 digital temperature sensors to platforms like Arduino or other...

The USB to TTL UART converter with the CP2102 chip is used to connect devices with a UART interface (microcontrollers, development boards, routers, GPS modules, etc.) to a...

Universal development board-programmer for ESP8266 modules with CH340 converter. Enables easy firmware uploading (Arduino IDE, PlatformIO, NodeMCU, MicroPython) as well as power...

ESP-Prog UART, JTAG programmer for ESP8266, ESP32, ESP32-S2, ESP32-S3 and ESP32-C3 microcontrollers.

Module enabling I2C bus extension with PCA9515A circuit.

The MCP2515 is a standalone CAN controller from Microchip that supports the CAN 2.0B specification and allows communication using standard and extended frames.

The MCP4725 DAC converter converts a digital value from a microcontroller into a true analogue voltage with 12-bit resolution (4096 levels).

Signal converter from 0-5V to 4-20mA current loop signal

The Texas Instruments ADS1115 breakout board provides precise analog-to-digital conversion for measurement applications where a microcontroller's standard 10-bit ADC is...

The module with the TJA1021 circuit serves as an interface between the LIN (Local Interconnect Network) bus and a microcontroller with a UART interface.

A converter between the serial TTL bus and the two-wire RS 485 bus that is most commonly used in industrial environments with the MAX485 chip.

TTL to RS232 bus converter with MAX3232 chip

Isolator for galvanic isolation of USB 2.0 bus. Insulation capacity up to 1500V.

The WCH-LinkE-RO-1v3 USB programmer and debug adapter is a compact tool designed for programming and debugging WCH microcontrollers (such as the CH32, CH57, CH58, CH32V...

USB to FIFO, SPI, I2C, IIC, JTAG and UART converter, FT2232HL