Converters & Programmers, Page 2

1-channel module for galvanic separation of input and output.

Universal programmer with USB-UART converter CH9102 intended for uploading firmware (not only) to development kits LaskaKit.

LaskaKit I2C 5V to 3.3V micro-USB Logic Level Converter is a miniature board that allows connecting 3.3V sensors and modules with a micro-USB connector to 5V logic control...

Universal transmitter module for K, J, N, R, S, T, E and B thermocouples, MAX31856, SPI interface.

Converter between SPI and CAN buses, which is most often used in cars, this module is suitable for use in projects where this is necessary.

MAX6675K thermocouple converter for use with Arduino.

USB - UART converter and power source for Nextion displays.

It allows you to program your project without soldering connectors, save PCB space and possibly program small production runs.

Module for easy programming of ATtiny13A/ATtiny25/ATtiny45/ATtiny85 microcontrollers without the need to have them on the board.

Programming and test clamp for integrated circuits in SOP8 package with adapter and cable

Programming and test clamp for integrated circuits in SOP8 package

The R4DCB08 module is an 8-channel converter of DS18B20 temperature sensors to an RS485 industrial interface with Modbus RTU protocol.

The RS-232/UART to LAN or WiFi converter kit is designed for applications where it is necessary to transfer RS-232/UART communication via LAN/WiFi network to a remote device,...

The XY-IT0V converter converts a current signal from a 4-20 mA or 0-20 mA industrial loop into a 0-10 V voltage signal, which can be processed by a standard ADC converter,...

HX711 is a popular 24-bit A/D converter designed specifically for weighing applications with load cells.

The breakout module with the MAX232 circuit is used for bidirectional conversion between UART serial communication and the RS-232 standard.

ST-Link V2 programmer for boards with STM8 and STM32 microcontrollers.

UART to RS 485 converter, MAX485, supply voltage 5V

USB to I2C converter, FT200XD

USB to RS232 converter, CH340 with cable

USB to SPI converter, FT220X

USB TTL UART converter, FT232RL, DTR pin

Programmer for ESP-01 boards with CH340 chip.

The CH9102G component in the QFN-24 is suitable for conversion between several buses, most often USB and UART for programming.