LaskaKit OLED display 128x64 1.3" I²C

Product detailed description

The LaskaKit OLED display 128x64 1.3" with SH1106 controller and I²C bus is a high-contrast monochromatic display available in blue or white, equipped with two μŠup connectors and a position for a 2.54mm pin header. The μŠup connectors (compatible with Stemma QT and Qwiic) allow the display to be connected without soldering to other LaskaKit modules and boards – such as the SHT40 temperature and humidity sensor, the BME280 pressure sensor, or the SCD41 CO2 sensor. The display operates with a supply voltage of 3.3 to 5 V, the I²C bus is equipped with 10k pull-up resistors, and you can select address 0x3C or 0x3D via a solder bridge, allowing up to two displays to be connected to a single bus.

Specifications:

• Board version: 1.2
• Controller: SH1106
• Diagonal: 1.3"
• Resolution: 128 × 64 pixels
• Display colour: blue or white (depending on the selected variant)
• Interface: I²C, address 0x3C or 0x3D (selectable via I2C_ADDR solder bridge)
• Pull-up resistors: 10 kΩ on SDA and SCL
• Supply voltage: 3.3–5 V
• Current consumption: max. 100 mA
• Connectors:
  • μSup: 2× (compatible with Stemma QT and Qwiic)
  • Pin header: position for a 4-pin header with 2.54 mm pitch – the header is included in the package but not soldered; solder it as needed
• Dimensions: 34 × 36 mm
• Compatibility: Arduino, ESP32, ESP8266, Raspberry Pi and others (libraries e.g. U8g2 or Adafruit SH110X)

Package contents:

• 1× LaskaKit OLED display 128x64 1.3" I²C (depending on the selected variant)
• 1× 4-pin header, 2.54 mm pitch (unsoldered)

Note:

• This product is not a standalone functional unit and may require professional installation.
• Product images are for illustrative purposes only and may sometimes differ from the actual appearance of the item. However, this does not change their basic properties.
• Version 1.1 contains an error – the GND pin on the μŠup J2 connector is not connected to the rest of the GND signal, meaning the display will not function when connected via this connector. The μŠup J1 connector and the pin header are fully functional. This error has been corrected in version 1.2.