Data Storage & Transmission, Page 11

433MHz wireless remote EV1527 4-channels

Module for wireless communication at 433MHz frequency, it can be simply inserted into a non-soldering field.

Antenna 5dBi 19cm 2.4G white

Bluetooth module HC-05 - TTL, SMD design

The USB to TTL UART converter with the CP2102 chip is used to connect devices with a UART interface (microcontrollers, development boards, routers, GPS modules, etc.) to a...

Universal development board-programmer for ESP8266 modules with CH340 converter. Enables easy firmware uploading (Arduino IDE, PlatformIO, NodeMCU, MicroPython) as well as power...

eMMC microSD memory reader

The TX868-BLG-40 is a fiberglass antenna designed to operate in the 868 MHz band, with a length of approximately 400 mm and a straight male N-connector. Its fiberglass shell...

The TX868-BLG-40 is a fiberglass antenna designed to operate in the 868 MHz band, with a length of approximately 400 mm and a straight male N-connector. Its fiberglass shell...

HTIT-Wsh (Wireless shell) is a LoRa node module with long range, high reception sensitivity and low power consumption (approx. 9uA). HTIT-Wsh consists of an MCU (ESP32-S3FN8)...

The Heltec MeshPocket Qi2 Magnetic Wireless Powerbank is an innovative device that combines the functions of a magnetic wireless power bank with LoRa/BLE communication and an...

Wireless Tracker is a development kit based on ESP32-S3FN8. It integrates the SX1262 and UC6580 to provide a fast GNSS solution for IoT. It can track any object and then upload...

HopeRF RFM95W 868Mhz communication module

Module for wireless communication on 433MHz frequency.

KCX_BT_EMITTER is a Bluetooth audio transmitter – the opposite of common audio modules.

KR601E RFID access reader 125Khz Wiegand IP65

KR602E RFID access reader with keypad 125Khz Wiegand IP65

MCP23017 I2C 16 bit I/O Expander

The LoRa concentrator allows you to connect LoRa devices wherever there is insufficient provider signal coverage.

The MCP2515 is a standalone CAN controller from Microchip that supports the CAN 2.0B specification and allows communication using standard and extended frames.

Module with microSD card slot for data storage and retrieval, communicating with the board via SPI bus.

RFID card for use with readers, for example as a more convenient key or a way of recording attendance.

Round transparent 25mm diameter NFC tag with 180B total memory and 144B user memory (can store up to 132 characters). Equipped with the new NTAG213 chip achieving one of the...

NFC sticker inlay tag, NTAG213, 40x25mm 10pcs