Data Storage & Transmission, Page 2

Shield for Arduino UNO and MEGA, which allows using GPRS and GSM telecommunication networks for receiving and sending data. The module needs a SIM card with prepaid data.

Audio player for MP3 files from a microSD card that can be controlled with the Arduino board.

The 10–6000 MHz bias tee is used to inject DC power into a coaxial cable along with the RF signal, typically for powering active antennas and low-noise amplifiers (LNA) located...

The Bluetooth LED Badge is a programmable name badge with an LED display, allowing you to show your own text, symbols, or simple animations.

Bluetooth module HC-05 for wireless serial communication between the boards or board and a laptop or mobile phone with bluetooth.

The HC-06 Bluetooth module allows your board to wirelessly send and receive serial data via Bluetooth – to a mobile phone, computer, or another Bluetooth-enabled board.

Dual Bluetooth module JDY-33, 3.0 SPP + 4.2 BLE. Slave communication mode.

Dual Bluetooth module JDY-33, 3.0 SPP + 4.2 BLE. Slave communication mode. SMD design.

Improved Bluetooth module HC-05 - TTL, version 2.1+EDR, integrated logic level converter.

The BNC to SMA coaxial adapter is used to connect BNC-connector devices, such as oscilloscopes, generators or counters, with cables, antennas and modules with an SMA connector...

The CC1101 is a low-power wireless module operating in the 433 MHz band, utilising a modern RF chip from Texas Instruments. The module is suitable for bidirectional wireless...

The CC1101 is a low-power RF module operating in the 868 MHz band, designed for reliable wireless communication over short to medium distances. It uses a chip from Texas...

A coaxial pigtail cable with a U.FL (IPEX1) connector connects a wireless module to an external antenna or leads a high-frequency signal from the board out of the device.

The RG316 coaxial patch cable, 30 cm in length with SMA male connectors on both ends, is used for connecting RF devices, modules, antennas and measuring equipment.

PWM signal converter to 0-10V voltage.

TTL to RS422 converter, MAX490 Full Duplex

The UART to LAN converter is designed for applications where it is necessary to transfer serial UART communication via LAN to a remote device, e.g. PC, or a second converter...

USB to TTL UART converter, CH340 with cable and Dupont connectors.

Decawave DWM1000 - localization module

Practical development board-programmer for ESP-WROOM-32 modules with CH340 converter. It allows you to conveniently upload firmware (Arduino IDE, ESP-IDF, MicroPython) as well...

Digital isolator for galvanic isolation of UART data buses etc.

Module with extra EEPROM memory that does not reset with the board and can store information for a long time.

ESP Prog v1.0 programmer CH340 for ESP-01/S

Module for wireless serial communication via bluetooth between boards or motherboards and mobile phones or laptops with bluetooth.